Steel bush insert Ø20

Bush hammer insert in treated steel, connected to the bush hammer by a ø20 tenon system, held in place by a key.

For achieving a flat finish and a surface showing regular points on the material, either to texture the surface or make it slip-resistant, etc.

For all types of soft to semi-hard stone: concrete, marble, limestone, granite, etc.

Sections: 35 x 35 mm, 40 x 40 mm and 45 x 45 mm.

Wide range of teeth options

Manual use only:
– with a hand bushing bit holder 2 heads tenon MG taper (from the Hammering, Bush Hammering range)